|
In order to give you the quality and service you expect and deserve, we need adequate time for fabricating, inspecting and delivering your laboratory work. Please use the chart below as a guide in making your prosthetic appointments. When discussions about a particular case are necessary, please allow one extra day.
|
Porcelain Department
Porcelain fused to metal crown
Under 3 Units-5 days
Over 3 Units-7 days
Over 5 Units-10 days
Glazing and/or add on-2 days
Try-In (add)-2 days
|
|
Denture Department
Try-In-3-4 days
Finish-3 days
Rematerial (Transfer)-2 days
Stayplates-2 days
Non-Embarrassment Denture-2 days
|
|
Aesthetic Department
Aesthetic Work (add)-2 days
Porcelain Laminates-10 days
Composite Laminates-7 days
Composite Inlays/Onlays-5 days
|
|
Partial Department
Partial Casting with Bite Blocks-5 days
Immediate Partial, Finished-7 days
Tooth set-up (add)-2 days
Design, Look See (add)-2 days
|
Crown & Bridge Department
Under 5 Units-5 days
Over 5 Units-7 days |
|
|
Cases requiring less time than the above schedule should be discussed with the staff of A&M Dental Laboratories before being sent to the lab. Rush cases will be subject to an additional charge to cover overtime for our personnel. We realize that from time to time patients’ schedules require a rushed case, and we will do our best to accommodate them.
|
